Print
Chemical Datasheet

DENATURED ALCOHOL (TOXIC)

3
0 0
 

Chemical Identifiers

UN/NA Number CAS Number CHRIS Code DOT Hazard Label
  • 1986
none none
  • FLAMMABLE LIQUID
  • POISON
  • KEEP AWAY FROM FOOD
NFPA 704:
  • Red 3 -- Flammability: Ignites at normal temperatures
  • Blue 0 -- Health Hazard: Like ordinary material
  • Yellow 0 -- Reactivity: Normally stable
General Description
A clear colorless liquid with a characteristic odor. Consists of ethanol deliberately rendered toxic by the addition of hard-to-separate toxic substances. Flash point near 0° F. Less dense than water. Vapors heavier than air. Used as a fuel, solvent, antifreeze, and to make other chemicals.

Hazards

Reactivity Alerts
Air & Water Reactions
Highly flammable. Water soluble.
Fire Hazard
HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion and poison hazard indoors, outdoors or in sewers. Runoff to sewer may create fire or explosion hazard. Containers may explode when heated. Many liquids are lighter than water. (ERG, 2008)
Health Hazard
TOXIC; may be fatal if inhaled, ingested or absorbed through skin. Inhalation or contact with some of these materials will irritate or burn skin and eyes. Fire will produce irritating, corrosive and/or toxic gases. Vapors may cause dizziness or suffocation. Runoff from fire control or dilution water may cause pollution. (ERG, 2008)
Reactivity Profile
DENATURED ALCOHOL gives flammable and/or toxic gases with alkali metals, nitrides, and strong reducing agents. Reacts with oxoacids and carboxylic acids to form esters plus water. Reacts with oxidizing agents to give ethanal or acetic acid. Exhibits both weak acid and weak base behavior. May initiate the polymerization of isocyanates and epoxides.
Belongs to the Following Reactive Group(s)

Response Recommendations

Firefighting
Do not extinguish fire unless flow can be stopped. Use water in flooding quantities as fog. Solid streams of water may be ineffective. Cool all affected containers with flooding quantities of water. Apply water from as far a distance as possible. Use "alcohol" foam, dry chemical or carbon dioxide. (AAR, 2003)
Non-Fire Response
Keep sparks, flames, and other sources of ignition away. Keep material out of water sources and sewers. Build dikes to contain flow as necessary. Attempt to stop leak if without undue personnel hazard. Use water spray to knock-down vapors. Land spill: Dig a pit, pond, lagoon, holding area to contain liquid or solid material. Cover solids with a plastic sheet to prevent dissolving in rain or fire fighting water. Dike surface flow using soil, sand bags, foamed polyurethane, or foamed concrete. Water spill: Use natural barriers or oil spill control booms to limit spill travel. Remove trapped material with suction hoses. (AAR, 2003)
Protective Clothing
Avoid breathing vapors. Keep upwind. Wear appropriate chemical protective gloves, boots and goggles. Do not handle broken packages unless wearing appropriate personal protective equipment. Wash away any material which may have contacted the body with copious amounts of water or soap and water. (AAR, 2003)
First Aid
Move victim to fresh air. Call 911 or emergency medical service. Give artificial respiration if victim is not breathing. Do not use mouth-to-mouth method if victim ingested or inhaled the substance; give artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. Administer oxygen if breathing is difficult. Remove and isolate contaminated clothing and shoes. In case of contact with substance, immediately flush skin or eyes with running water for at least 20 minutes. Wash skin with soap and water. In case of burns, immediately cool affected skin for as long as possible with cold water. Do not remove clothing if adhering to skin. Keep victim warm and quiet. Effects of exposure (inhalation, ingestion or skin contact) to substance may be delayed. Ensure that medical personnel are aware of the material(s) involved and take precautions to protect themselves. (ERG, 2008)

Physical Properties

Molecular Formula: data unavailable
Flash Point: 0.0 ° F approx. (AAR, 2003)
Lower Explosive Limit: data unavailable
Upper Explosive Limit: data unavailable
Autoignition Temperature: data unavailable
Melting Point: data unavailable
Vapor Pressure: data unavailable
Vapor Density: data unavailable
Specific Gravity: data unavailable
Boiling Point: data unavailable
Molecular Weight: data unavailable
Water Solubility: data unavailable
AEGL: data unavailable
ERPG: data unavailable
TEEL: data unavailable
IDLH: data unavailable

Regulatory Information

Regulatory Names: none
CAA RMP: Not a regulated chemical.
CERCLA: Not a regulated chemical.
EHS (EPCRA 302): Not a regulated chemical.
TRI (EPCRA 313): Not a regulated chemical.
RCRA Chemical Code: none

Alternate Chemical Names