Chemical data sheet for:

METHDILAZINE HYDROCHLORIDE

 Add to MyChemicals       Print Report 

Section 1 - Chemical Identifiers Section 4 - Physical Properties
Section 2 - Hazards Section 5 - Regulatory Information
Section 3 - Response Recommendations Section 6 - Alternate Chemical Names
Section 1 - Chemical Identifiers
Back to top | What is this information?
CAS NumberUN/NA NumberSTCC NumberCHRIS Code
  • 1229-35-2
none none none
NFPA 704:
NO CODES
      DOT Hazard Label: data unavailable
General Description
PHYSICAL DESCRIPTION: White microcrystalline powder with a slight odor. pH (1% aqueous solution) 4.8-6. (NTP, 1992)
Section 2 - Hazards
Back to top | What is this information?
Reactivity Alerts
none
Air & Water Reactions
Water soluble. pH (1% aqueous solution) 4.8-6 [NTP, 1992].
Fire Hazard
Flash point data for this chemical are not available; however, it is probably combustible. (NTP, 1992)
Health Hazard
SYMPTOMS: Symptoms of exposure to this compound may include drowsiness, dizziness, lassitude, tinnitus, incoordination, fatigue, blurred vision, euphoria, diplopia, nervousness, insomnia, tremors, grand mal seizures, catatonic-like states, neuritis and hysteria. It may cause bradycardia, cardiac arrest, anorexia, epigastric distress, constipation, dry mouth, urticaria, dermatitis, asthma, laryngeal edema, photosensitivity, lupus erythematous-like syndrome, anaphylactoid reactions, leukopenia, agranulocytosis, thrombocytopenic purpura and jaundice of the obstructive type. In children, symptoms may include excitation, hallucinations, convulsions and sudden death. In elderly people, it may cause hypotension, syncope, toxic confusional states, excessive sedation, extrapyramidal signs, akathisia and persistent dyskinesia.

ACUTE/CHRONIC HAZARDS: When heated to decomposition this compound emits toxic fumes of nitrogen oxides and hydrochloric acid. (NTP, 1992)
Reactivity Profile
METHDILAZINE HYDROCHLORIDE is sensitive to exposure to light. [NTP, 1992] An acidic salt. Materials in this group are generally soluble in water. The resulting solutions contain moderate concentrations of hydrogen ions and have pH's of less than 7.0. They react as acids to neutralize bases. These neutralizations generate heat, but less or far less than is generated by neutralization of inorganic acids, inorganic oxoacids, and carboxylic acid. They usually do not react as either oxidizing agents or reducing agents but such behavior is not impossible. (NOAA REACTIVITY, 2007)
Belongs to reactive group(s)
Section 3 - Response Recommendations
Back to top | What is this information?
Fire Fighting
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Non-Fire Response
SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

STORAGE PRECAUTIONS: You should protect this material from exposure to light and store it in a refrigerator. (NTP, 1992)
Protective Clothing
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.

RECOMMENDED GLOVE MATERIALS: The GlovES+ expert system was used to extrapolate permeation test information from compounds in the same chemical class. The GlovES+ system uses permeation data from literature sources; therefore, extra safety margins should be used with the estimated protection time(s). If this chemical makes direct contact with your gloves, or if a tear, puncture or hole develops, replace them at once.

Glove Type Model Number Thickness Bkthru Time
Butyl North B-174 0.63 mm 480 min
Natural Rubber Ansell 304 0.18 mm 240 min
Neoprene Edmont 29-870 0.46 mm 480 min
PVC Edmont 34-100 0.16 mm 240 min (NTP, 1992)
First Aid
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. If symptoms (such as redness or irritation) develop, immediately transport the victim to a hospital.

SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.

INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.

INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
Section 4 - Physical Properties
Back to top | What is this information?
Molecular Formula:
  • C18H20N2S.ClH

Flash Point: data unavailable

Lower Explosive Limit: data unavailable

Upper Explosive Limit: data unavailable

Auto Ignition Temperature: data unavailable

Melting Point: 370-372 ° F (NTP, 1992)

Vapor Pressure: data unavailable

Vapor Density: data unavailable

Specific Gravity: data unavailable

Boiling Point: data unavailable

Molecular Weight: 332.92 (NTP, 1992)

Water Solubility: 50-100 mg/mL at 63° F (NTP, 1992)

AEGL: data unavailable

ERPG: data unavailable

TEEL: data unavailable

IDLH: data unavailable

Section 5 - Regulatory Information
Back to top | What is this information?
Regulatory Names
No information available.

CAA RMP: Not a regulated chemical.

CERCLA: Not a regulated chemical.

EPCRA 302 EHS: Not a regulated chemical.

TRI (EPCRA 313): Not a regulated chemical.

RCRA chemical code: none

Section 6 - Alternate Chemical Names
Back to top | What is this information?